Note: Once you click save, the internet lights on your ZTE F689 may go out or turn red. This is normal.
To configure bridge mode on a (or similar ZXHN models), you typically need to access the web interface and adjust the WAN settings. Note that many Internet Service Providers (ISPs) disable this feature remotely, and you may need to contact them to have it enabled. How to Access Bridge Mode Settings Login to the Web Interface
This method requires caution. Changing the wrong VLAN or interface can kill your VoIP phone or IPTV. Zte F689 Bridge Mode
How to Configure ZTE F689 Bridge Mode: A Step-by-Step Guide Setting up your ZTE F689 ONT/Router in bridge mode is the best way to improve your home network. By default, this ISP-provided gateway acts as both a modem and a router. This dual functionality often leads to signal dead zones, limited configuration options, and a networking headache known as Double NAT (Network Address Translation).
This is the critical step.
Bypass the ISP’s basic hardware to use advanced features on routers from brands like Cisco, Ubiquiti, or ASUS.
Keeps your entire local network under a single, unified management interface. Prerequisites Before Configuration Note: Once you click save, the internet lights
Disclaimer: Some ISPs lock bridge mode capabilities. If you cannot find these settings, you may need to call your ISP to bridge it for you. 1. Access the ZTE F689 Management Interface Connect your computer to any LAN port on the F689. Open a browser and type the default IP address: or . Log in with your administrator credentials. 2. Locate the WAN Settings Navigate to Network or Internet in the top menu. Select WAN and then WAN Connection .