One of the most common failures occurs when the operator does not press the exact center of the crosshair during calibration. If your finger is slightly off the crosshair target, the system saves that offset. Fix: Re-run the calibration, ensuring a steady, vertical press on the center point.
: After calibration, the screen registers no touches at all. mcgs hmi touch calibration
While the MCGS HMI is running, hold down a specific corner of the screen (usually the top-left or top-right) for 3-5 seconds, or press the System button if available. One of the most common failures occurs when
Regardless of which method you used to access calibration, the actual calibration procedure follows a consistent pattern across all MCGS HMI models. ensuring a steady