V200 Shower Instructions [updated] - Caraflo

Are you currently experiencing a like a leak or temperature failure?

Rotate the temperature handle (often the left or top handle) to adjust the warmth. caraflo v200 shower instructions

: The unit typically includes a specific drain-down key in the original box. Are you currently experiencing a like a leak

Any work on the thermostatic mixing unit should be carried out by a suitably qualified competent person. Any work on the thermostatic mixing unit should

The hot water supply must connect strictly to the inlet marked HOT (H) , and the cold water supply must connect to the inlet marked COLD (C) . Step 2: Mounting the Valve Body Caraflo V200

| | Possible Cause | Suggested Remedy | |-------------|--------------------|----------------------| | No water flow | Inlet supplies reversed (hot on cold, cold on hot) | Check and correct pipe connections | | | Filters or strainers blocked | Clean the filters (see “Maintenance” section) | | | No hot water reaching the mixer | Check water heater operation | | | Water supply isolated | Ensure mains feed taps are fully open | | Low or fluctuating flow | Kinked or damaged shower hose | Inspect and replace hose if necessary | | | Blocked filters | Clean the inlet filters as described above | | | Low system pressure | Verify pressure meets requirements (see below) | | Temperature too hot | Cold water supply failure (fail‑safe should shut off) | Immediately turn off flow . Check cold supply. If problem persists, replace thermostatic cartridge. | | | Thermostat incorrectly adjusted | Adjust internal temperature setting | | | Hot water supply exceeds 65°C | Check water heater settings – maximum allowed is 65°C | | Temperature too cold | Hot water supply too low (below 55°C) | Check water heater – minimum required is 55°C | | | Thermostat incorrectly adjusted | Adjust internal temperature setting | | | Pressure imbalance between hot and cold supplies | Install pressure balancing device or check system design | | Leak from the valve body | Worn O‑rings or seals | Replace damaged seals. Use genuine Caraflo parts. | | | Mixer not tightly seated on tails | Remove, clean, and re‑tighten grub screws | | Leak from shower head connection | Loose or damaged hose washer | Replace the washer or tighten the connection | | Water runs cold when flow is turned back on during shower | Normal thermostatic behaviour | Allow a few seconds for the valve to recover to set temperature | | | Thermostatic cartridge sluggish | Consider replacing the cartridge |