Brushless Esc V2.3 Manual !!top!! | Recent & Pro

Brushless ESC V2.3 manual, V2.3 programming instructions, brushless ESC beep codes, calibrate V2.3 throttle, RC ESC troubleshooting.

The V2.3 architecture introduces upgraded MOSFETs and an enhanced microcontroller unit (MCU) capable of handling higher PWM frequencies. This results in smoother throttle responses and lower operating temperatures. Specification 60A (with proper airflow) Peak Current (10 sec) Input Voltage Range 2S–6S LiPo (7.4V – 22.2V) BEC Output Switch-mode: 6.0V / 7.4V adjustable (5A) MCU Architecture 32-bit ARM Cortex Supported Protocols PWM, OneShot, DShot300/600, ProShot Weight / Dimensions 42g / 55mm x 28mm x 12mm Protection Systems Thermal, Low-Voltage Cutoff, Signal Loss Wiring and Connection Diagrams brushless esc v2.3 manual

Low-voltage cutoff, over-heat protection (shuts down if surface temp exceeds 110°C), and throttle signal loss protection. 2. Installation and Wiring Brushless ESC V2

| Menu # | Beep Pattern | Parameter | Options (Move throttle up/down, then save) | | :--- | :--- | :--- | :--- | | 1 | 1 short beep | Brake Type | 1 Beep=Off (Default) / 2 Beeps=Soft / 3 Beeps=Hard | | 2 | 2 short beeps | Battery Type | 1 Beep=LiPo (Default) / 2 Beeps=NiMH | | 3 | 3 short beeps | Cutoff Voltage (Low Voltage Protection) | 1 Beep=Low (2.8V/Cell) / 2 Beeps=Med (3.0V) / 3 Beeps=High (3.2V) | | 4 | 4 short beeps | Timing Advance | 1 Beep=Low (For 2-pole motors) / 2 Beeps=Med (Most outrunners) / 3 Beeps=High (High RPM) | | 5 | 5 short beeps | Start Mode (Punch) | 1 Beep=Soft / 2 Beeps=Normal (Default) / 3 Beeps=Aggressive | | 6 | 1 long beep | PWM Frequency | 1 Beep=8kHz (Default) / 2 Beeps=16kHz | | 7 | 1 long+1 short | Motor Rotation (Locked) | Use wire swap instead | Specification 60A (with proper airflow) Peak Current (10